EN - How to do maintenance on an aspirator box

        

Question

How to do maintenance on the aspirator box

 Answer 

Example of a wick with dry residue (similar to lime). This gives a wrong RH measurement.

Solution is to cut off a piece of the wick and use demineralized water.

As you can see in the table below, the maintenance consists of:

• filter
  
• water bottle
  
• wick
  
• fan
  

• Related Articles

• EN - 740600 - Aspirator box dry & wet bulb

     This article is only for Hoogendoorn Partners Question How to connect the aspirator box?  Answer  Read the attached installation and service manual. Click this link to see how to calibrate the aspirator box Click this link to read how to do ...

• IIVO - Troubleshooting Aspirator box

  Greenhouse temperature is not measured properly with a dry/wet bulb aspirator box At a distance (online) Carefully read the installation manual on the PartnerWiki Check whether real time values are received in I/O CONFIGURATION Check whether the ...

• EN - How to switch off the fan in the aspirator box while using sulphur pots

     Question When you are burning sulphur to prevent mildew then it is highly recommanded to switch off the fan of the aspirator box. Otherwise the inside of the aspirator box becomes nasty and the sulfur affects the sensors which drastically shortens ...

• EN - How an aspirator box works

       Question There is an aspiratox box installed. How does the aspirator box work?  Answer  The greenhouse temperature can be measured by an aspirator box. Inside the aspirator box there is a PT500 sensor. This sensor is made of Platinum (PT) and ...

• EN - How to do maintenance on sensors

       Question How to do maintenance on sensors?  Answer  Take a look to the attached schedule.