EN - How to do maintenance on sensors

    

Question

How to do maintenance on sensors?

 Answer 

Take a look to the attached schedule.

• Related Articles

• NL - Hoe onderhoud je sensors

  Vraag Hoe onderhoud je sensors? Antwoord Bekijk het bijgevoegde schema.

• EN - How to do maintenance on a pH sensor

         Question How to do maintenance on a pH sensor?  Answer  As you can see in the table below, you can clean the sensor with clean water. Watch the video below how to calibrate an pH sensor: The calibration procedure in steps: ​In this video we ...

• EN - How to commission Ritec sensors?

                  How to commission Ritec sensors?

• EN - 025930 - How to use +PAR module?

  Question I have a PAR sensor in the greenhouse and the software module +PAR. How to use the +PAR module? Answer The iSii + PAR module is optional from version 3.3.3.1 or higher. With this module you can control the PAR value under the (partly) closed ...

• EN - How to mount Jumo EC sensors?

  How to mount Jumo EC sensors? See below the general recommendations of Jumo. 1. The ideal mounting: 2. Avoid dead zones or places where air can accumulate: 3. Avoid areas where air can remain. For example, at the end of a pipe: 4. Avoid areas where ...