EN - How to connect a Netafim unit

This article is only for Hoogendoorn Partners

Question

How to connect a Netafim unit?

 Answer 

Please read te attached product sheet, installation manual and user manual.

1. You need a Datapoint with a normal C150 bus-coupler (so you don't need a C150e bus-coupler).
   The Datapoint must have the following modules:
   - 3 x Din
   - 6 x Aout
   - 4 x Dout
   
   
   
   
2. Then make the following connections in Connect IO:
   
   
   
   
3. You don”t have to connect hardware to “ ABCD controller: computed cycle time” and “ ABCD controller: computed minimum length actuation pulse”
   
   
4. Use as type of valve "on/off - open close valve"
   
   
   
   
5. Enter a correction value of 1 in the setting "ABCD controller: active: detection"
   
   
   
   
6. Enter the settings of the cycle time
   
   
   
   
7. The settings of the 4 trays
   
   
   
   
8. For the pH you need extra 2 x Dout modules and a 530605 Ramp generator PR2281

• Related Articles

• EN - How to connect to iSii compact?

     This article is only for Hoogendoorn Partners Question How to connect to iSii compact?  Answer  Via LAN 1 you can connect your laptop or desktop directy to the iSii compact. Or you can use a Wifi router. The default IP address of the iSii compact ...

• EN - How to get fixed fields in a task report in Work-IT - Task Speed unit fields

  Question How to get fixed fields in a "Tasks per day" report ? So i don't need to customize it every time. ​  Answer  The task speed units are a set factor. For each task speed unit, the fields that are necessary to calculate the speed can be ...

• EN - How to connect +Active Air modules

  Question How do I connect +Active Air modules ?  Answer 

• EN - 635805 - Pyrgeometer Hukseflux IR02

     This article is for Hoogendoorn Partners Question The heat emission can be measured with a pyrgeometer. This heat emission can vary between 0 and -150 W / m2.   How to connect a pyrgeometer?  Answer  Read the attached installation manual and ...

• EN - How to work with +Active Air heating

  Question How do I work with +Active Air heating?  Answer  The Active Air heating is used in the following situations: The computed temperature of the heating element is between the minimum and maximum temperature. The pump is switched on when the ...