EN - How to switch off the fan in the aspirator box while using sulphur pots

  

Question

When you are burning sulphur to prevent mildew then it is highly recommanded to switch off the fan of the aspirator box.

Otherwise the inside of the aspirator box becomes nasty and the sulfur affects the sensors which drastically shortens the life of the sensors.

How to switch off the fan in the aspirator box while using sulphur pots?

 Answer 

The most simple way is to fill in the timer below.

• Related Articles

• EN - 740600 - Aspirator box dry & wet bulb

     This article is only for Hoogendoorn Partners Question How to connect the aspirator box?  Answer  Read the attached installation and service manual. Click this link to see how to calibrate the aspirator box Click this link to read how to do ...

• EN - How an aspirator box works

       Question There is an aspiratox box installed. How does the aspirator box work?  Answer  The greenhouse temperature can be measured by an aspirator box. Inside the aspirator box there is a PT500 sensor. This sensor is made of Platinum (PT) and ...

• EN - How to work with +Active Air fan

  Question How do I work with +Active Air fan ?  Answer  The fan must run at a minimum speed of 40%. The Active Air fan is used in the following situations: In the example above the fan speed is from 40 to 100% when the greenhouse temperature is from ...

• IIVO - Troubleshooting Aspirator box

  Greenhouse temperature is not measured properly with a dry/wet bulb aspirator box At a distance (online) Carefully read the installation manual on the PartnerWiki Check whether real time values are received in I/O CONFIGURATION Check whether the ...

• EN - How to calibrate an aspirator box

     This article is only for Hoogendoorn Partners Question How can I calibrate an spirator box?  Answer  Watch the video below how to calibrate the aspirator box: The calibration must be done in Access level: Service. 1. Double click on Aspirators 2. ...